Ethshield

From MGH Designs wiki
Revision as of 22:48, 17 September 2016 by Martin Hodge (talk | contribs) (Created page with "== Connecting the Ethernet Shield R3 to the Propeller ASC == === Align the pins as shown. (Click to enlarge) === link=|200x175px| file:dscf6800s.jpg|...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Connecting the Ethernet Shield R3 to the Propeller ASC

Align the pins as shown. (Click to enlarge)

Note: the two extra pins on the top and bottom of the R3 version will dangle unconnected as shown. The Previous version of the Ethernet Shield does not have these extra pins.

Bypass Jumper Configuration

The Ethernet Shield is a 3.3v device and does not require the Propeller ASC's built-in current-limiting resistors. You will need to use a soldering iron and a drop of solder on the pads shown on the bottom of the Propeller ASC. 

 This page is still under construction!
Retrieved from "https://1mgh.com/w/index.php?title=Ethshield&oldid=58"