Falcon Ethernet

Click image to enlarge	Remove the screws indicated. Flip the computer right side up and lift off the top half of the case
Click image to enlarge	Unplug the keyboard and set it aside.
Click image to enlarge	Remove the screws indicated and partially lift the RF shield up.
Click image to enlarge	Unplug the speaker from the main board and set the RF shield/speaker assembly aside.
Click image to enlarge	Remove the screws indicated and remove the RF shield from the floppy drive.
Click image to enlarge	Remove the screws indicated and unplug and remove the power supply and HD bracket.
Click image to enlarge	Unplug the power and data cables from the floppy disk drive.
Click image to enlarge	Remove the the screws indicated and the floppy drive should come away from the main board.
Click image to enlarge	Remove the hex studs indicated and pull the RF shield strip off of the back of the unit. (You may need to bend the tabs away from the RCA connector)
Click image to enlarge	Remove the screws indicated and separate the upper RF shield from the board.
Click image to enlarge	Desolder the grounding braids from the RF shield and remove the main board from the shield.
Click image to enlarge	Begin desoldering the parts indicated from the underside of the main board.
Click image to enlarge	This image shows which parts (J19, L86-L93, and L95) will need to be de-soldered in order to make room for the adapter. Also be sure to remove the small jumper from the two pins on J20 before plugging in the adapter.
Click image to enlarge	There is a narrow lip that will need to be folded inward to make clearance for the adapter. A ordinary pair of pliers will accomplish this easily. (Or you may elect to grind this lip off completely with a rotary tool.)
Click image to enlarge	Plug the adapter into the expansion port.
Click image to enlarge	Begin re-assembling the Falcon following the above steps in reverse order.
Click image to enlarge
Click image to enlarge